Step

Action

Device

☐ 1

Optional: enter flight route. This is needed to use the LNAV and VNAV autopilot modes.

CP

☐ 1.1

Alternative 1: Enter flight route manually

CP

☐ 1.2

Alternative 2: Load stored route from database

CP

☐ 2

Optional: Tune the ILS receiver

CP

☐ 2.1

Enter the ILS frequency on the FMS NAV RAD page

CP

☐ 3

Configure the ND appropriately on display control panel:

Recommended is MAP mode, TERR on (TERR off if the system performance is marginal)

CP

☐ 4

Enter the momentary charged battery capacity (or the full battery capacity if it is charged fully) into the TOT BAT CAP attribute on the INIT -> PERF FMS page

CP

☐ 5

On the same FMS page, enter the battery capacity, which shall be considered as reserve into the RES BAT CAP attribute.